Internal combustion engine control module.
New actuator functions and RPM based start/restart logic.
Not enabled by default.
---------
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
Co-authored-by: Pernilla <pernilla@auterion.com>
This will send the System message if it is already being sent by a ground
station. Otherwise, it will assemble the message itself using the
takeoff/home location.
Improve the slow down effect and add support for speed change in mission mode.
Seperate code related to turning setpoints into motor commands into its own folder and refactor code.
The voxl2 has a split architecture. PX4 runs on a posix platform and a Qurt platform. The two communicate uorb topics back and forth with the muorb module. But each has it's own parameters database and they need to stay in sync with each other. This PR adds support to keep the 2 parameter databases in sync. The main parameters database running on Linux has file system support while the Qurt one does not. The Linux side is considered the primary and the Qurt side is considered the remote.
* battery: make time remaining estimation dependent on level flight characteristis for FW
* battery: fix that FW flight is also correctly detected when vehicle_status is not updated
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
* FixedwingPositionControl: Move constant to header file
* flight phase estimation: use tecs height rate reference to check for level flight
---------
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
Co-authored-by: Silvan Fuhrer <silvan@auterion.com>
Reduces flash usage by ~16KB.
- compress formats at build-time into a single string with all formats
- then at runtime iteratively decompress using
https://github.com/atomicobject/heatshrink
The command is sent by a dedicated mavlink command and forwarded to the fixed wing position controller.
The pattern is defined by the radius of the major axis, the radius of the minor axis and the orientation. The pattern is then defined by:
The upper part of the pattern consist of a clockwise circle with radius defined by the minor axis. The center of the circle is defined by the major axis minus the minor axis away from the pattern center.
The lower part of the pattern consist of a counter-clockwise circle with the same definitions as above.
In between, the circles are connected with straight lines in a cross configuration. The lines are always tangetial to the circles.
The orientation rotates the major axis around the NED down axis.
The loitering logic is defined inside its own class used by the fixed wing position control module. It defines which segment (one of the circles or lines) is active and uses the path controller (npfg or l1-control) to determine the desired roll angle.
A feedback mavlink message is send with the executed pattern parameters.
chfriedrich98