dominiho 276dc7fbbc added px4flow integral frame, adjusted px4flow i2c driver, adjusted postition_estimator_inav

2014-10-28 12:35:20 +01:00

..

airspeed

Do not perform retries in airspeed driver - this is too much load for the HRT queue

2014-08-18 20:07:55 +02:00

ardrone_interface

ardrone: Optimize for size, since performance is good at any rate

2014-07-12 19:34:06 +02:00

blinkm

blinkm: Make driver flash efficient

2014-07-12 21:33:09 +02:00

bma180

Pass over drivers to reduce build size

2014-07-23 08:24:56 +02:00

boards

FMUv2: Add missing declarations.

2014-10-09 11:14:13 +02:00

device

device: initialise device id

2014-10-08 10:39:17 +02:00

ets_airspeed

Remove absolute pressure field as its not useful and confusing anywary

2014-08-24 11:49:45 +02:00

frsky_telemetry

frsky: Optimize for size

2014-07-12 19:34:28 +02:00

gps

Checking if fix status is less or equal to 0 rather than just equal

2014-10-10 18:42:24 +04:00

hil

Merged master

2014-08-09 12:22:28 +02:00

hmc5883

Reset excitement mode for hmc5883 sensor before applying a new one to avoid getting reserved 11 bits set in case of a set_excitement(1) call following a set_excitement(-1) call.

2014-08-20 13:06:39 +03:00

hott

Update ORB topic 'esc_status'

2014-10-13 17:01:34 +04:00

l3gd20

Merge sensor_startup_cleanup

2014-07-16 15:26:22 +02:00

led

Pass over drivers to reduce build size

2014-07-23 08:24:56 +02:00

ll40ls

ll40ls: start a measurement after a probe

2014-10-28 21:03:59 +11:00

lsm303d

lsm303d: don't use DRDY when not on internal SPI bus

2014-10-08 10:38:27 +02:00

mb12xx

mb12xx: flash efficiency

2014-07-12 21:33:34 +02:00

md25

Pass over drivers to reduce build size

2014-07-23 08:24:56 +02:00

meas_airspeed

Remove absolute pressure field as its not useful and confusing anywary

2014-08-24 11:49:45 +02:00

mkblctrl

Update ORB topic 'esc_status'

2014-10-13 17:01:34 +04:00

mpu6000

Set filter frequency for hardware and software in parallel, always do so in the same order

2014-09-30 10:05:39 +02:00

ms5611

add param for qnh

2014-08-17 10:45:30 +02:00

pca8574

PCA8574: flash efficiency

2014-07-16 15:17:54 +02:00

pca9685

pca9685: correct input scaling

2014-08-21 09:30:29 +02:00

px4flow

added px4flow integral frame, adjusted px4flow i2c driver, adjusted postition_estimator_inav

2014-10-28 12:35:20 +01:00

px4fmu

Ignore single channels during PWM output

2014-08-26 14:38:32 +02:00

px4io

Enable flaps, avoid mode switch position

2014-10-16 22:57:27 +02:00

rgbled

RGBLED: flash efficiency

2014-07-16 15:18:07 +02:00

roboclaw

Pass over drivers to reduce build size

2014-07-23 08:24:56 +02:00

sf0x

Fix unsigned comparison

2014-10-11 00:28:14 +02:00

stm32

Tone alarm sound for barometer check fail

2014-08-01 09:24:07 +02:00

drv_accel.h

drivers: Up to three units support

2014-07-15 23:20:02 +02:00

drv_adc.h

…

drv_airspeed.h

…

drv_baro.h

introduce multi device support on uORB

2014-06-10 15:03:58 +02:00

drv_blinkm.h

…

drv_device.h

device: added a _device_id to all drivers

2014-07-12 16:25:43 +02:00

drv_gpio.h

Add Gumstix AeroCore device

2014-05-13 09:41:41 -07:00

drv_gps.h

Ashtech GPS driver

2014-09-30 15:44:47 +04:00

drv_gyro.h

drivers: Up to three units support

2014-07-15 23:20:02 +02:00

drv_hrt.h

Add missing header in HRT

2014-04-28 19:21:37 +02:00

drv_io_expander.h

PCA8574 driver: Cleanup, ready for final testing and production

2014-05-29 12:24:50 +02:00

drv_led.h

…

drv_mag.h

drivers: Up to three units support

2014-07-15 23:20:02 +02:00

drv_mixer.h

…

drv_orb_dev.h

…

drv_pwm_output.h

Fix 8+ channel binding

2014-10-12 11:38:34 -07:00

drv_px4flow.h

px4flow: removed flow report in driver, just use uORB topic

2014-08-25 13:13:07 +02:00

drv_range_finder.h

Better Doxygen for topics, no code changes

2014-07-11 14:24:07 +02:00

drv_rc_input.h

IO input driver: Output ST24 as receiver type / status

2014-10-07 09:36:42 +02:00

drv_rgbled.h

…

drv_sbus.h

Add support in the IO driver to control the S.Bus / RSSI port.

2014-01-26 14:22:54 +01:00

drv_sensor.h

…

drv_tone_alarm.h

Tone alarm sound for barometer check fail

2014-08-01 09:24:07 +02:00