- no longer start sercon or mavlink usb by default
- on USB connection (VBUS) monitor serial USB at low rate and start Mavlink if there's a HEARTBEAT or nshterm on 3 consecutive carriage returns
- the mavlink USB instance is automatically stopped and serdis executed if USB is disconnected
- skipping Mavlink USB (and sercon) saves a considerable amount of memory on older boards
Using mixers on the IO side had a remote benefit of being able to
override all control surfaces with a radio remote on a fixed wing.
This ended up not being used that much and since the original design
10 years ago (2011) we have been able to convince ourselves that the
overall system stability is at a level where this marginal benefit,
which is not present on multicopters, is not worth the hazzle.
Co-authored-by: Beat Küng <beat-kueng@gmx.net>
Co-authored-by: Daniel Agar <daniel@agar.ca>
EKF2 has a grace period of 10 seconds after boot where it doesn't need
to warn the user while the sensors (especially GNSS) are still
converging.
A connection to a GCS shouldn't skip this grace period but
an arming request should.
* commander: send parachute command on termination
This sends the DO_PARACHUTE command to parachute component.
* commander: fix lying comments and printf
* commander: use one flag for termination triggered
This merges the duplicate flags _flight_termination_triggered and
_flight_flight_termination_printed.
* commander: correct variable name
* commander: always send tune with parachute
* commander: fix target_component for parachute cmd
The previous changes were wrong in that all commands were now sent to
the parachute component which doesn't make any sense. Of course only the
parachute command should be sent there.
When user override using the RC sticks is allowed, I would expect this
feature to also work in the case where GPS is lost and the vehicle goes
into a blind land/descent.
Without this commit, the vehicle would switch to Land mode and a pilot
could not take over control unless they switch to Altitude control in
a ground station.
With this commit, user override works as I would expect it and it will
switch to Altitude control allowing a pilot to recover in this
situation.
This is to avoid race condition with the yaw emergency estimator having
the same trigger delay of 1 second. Commander will now give more time to
EKF2 to reset itself before switching to altitude mode.
If you're flying in manual position control mode and lose position the state machine will put you in altitude control mode. Extending the reliant on optical flow relaxed position validity thresholds allows you to potential get back into position control mode with flow alone.
- handle SET_POSITION_TARGET_LOCAL_NED and SET_POSITION_TARGET_GLOBAL_INT with ORB_ID(trajectory_setpoint)
- FlightTaskOffboard not needed at all
- bypass position_setpoint_triplet entirely (start removing extraneous fields)
- simplify offboard_control_mode to map to supported control modes
Daniel Agar