- remove internal accumulation and publish every valid raw sample synchronized with sensor
- store timestamp_sample from motion interrupt
- improve timing requirements from datasheet (minimum delays after register read/write)
- all sources of optical flow publish sensor_optical_flow
- sensor_optical_flow is aggregated by the sensors module, aligned with integrated gyro, and published as vehicle_optical_flow
Co-authored-by: alexklimaj <alex@arkelectron.com>
- configure a backup schedule when using motion interrupt otherwise the
sensor will stop publishing entirely in the dark
- as a precaution issue full reset if sensor is stuck in a bad state
(no vaid data for an extended period)
- update light mode change criteria to match datasheet exactly
- fully respect datasheet quality and shutter metrics for mode changes
- use MOTION pin for scheduling if available
- log light mode
- refactor common enable LED code
- respect read and write time delays
- verify register writes
- cleanly reset on lighting mode changes as per the datasheet
- perf counters for mode switches and other errors
- cleanly reset on false motion detection
- minimize sleep on reset
- allowing setting custom rotation yaw angle directly on command line with -Y (ignoring SENS_FLOW_ROT)
- enable LED output
1. The spec specifies that the mode change condition should be met for 10
consecutive frames before changing to the next mode.
2. The spec (and comment) says that "PAW3902JF should not operate with Shutter < 0x01F4 in Mode 2" -
however the if condition checked the reverse condition
Signed-off-by: Koby Aizer <koby.aizer@tg-17.com>
* adds a work_queue systemcmd that will bring a tree view of all active work queues and work items
* WorkQueues now track attached WorkItems and will shutdown when the last WorkItem is detached
alexklimaj