JacobCrabill
10019bbccc
fmu-v5_uavcanv1: Increase CAN FIFOSIZE to 32
2021-07-06 22:00:07 -04:00
Daniel Agar
5f775b508f
boards: enable CONFIG_OTG_ID_GPIO_DISABLE on all F7/H7
2021-06-01 15:19:15 -04:00
David Sidrane
0385245ae1
px4_fmu-v5: Disable OTG_ID_GPIO
2021-05-05 20:48:06 +02:00
Daniel Agar
6874e9fba0
boards: NuttX disable all NSH memory debug commands (mb, mh, mw) by default
...
- closes https://github.com/PX4/PX4-Autopilot/issues/17062
2021-03-30 09:23:43 -04:00
Daniel Agar
205beb9526
boards: revert remaining CONFIG_ARMV7M_LAZYFPU
2021-03-17 09:58:23 -04:00
David Sidrane
f44a299e3b
px4_fmu-v5:Use Auto LSE Drive setting
2021-03-05 15:40:09 -05:00
Daniel Agar
cd7713eba2
boards: delete unused variants
2021-02-22 20:08:36 -05:00
Daniel Agar
8f0918a16b
boards: remove unused linker __param section
2021-02-08 23:22:48 -05:00
Peter van der Perk
8242968b2b
UAVCAN v1 GPS demo with MAVCAN autoconfigure
2021-02-07 17:18:45 +01:00
Daniel Agar
58ca575871
UAVCAN v1 bridge
...
- NuttX stm32f4/stm32f7 uses character device driver
- NuttX kinetis and s32k uses socketcan
2021-02-07 17:18:45 +01:00
Jukka Laitinen
5c9e7c2581
Add table of contents structure for px4_fmuv5 targets
...
Signed-off-by: Jukka Laitinen <jukkax@ssrc.tii.ae >
2021-01-27 08:36:08 +01:00
Daniel Agar
1ec10bfcc6
boards: disable CONFIG_ARMV7M_LAZYFPU again ( #16573 )
...
- this was causing hard faults on the CUAV Nora and possibly other boards, disabling everywhere until we fully understand the root cause
2021-01-17 22:40:21 -05:00
Daniel Agar
cb74cb8692
boards: enable CONFIG_ARMV7M_LAZYFPU everywhere
2021-01-12 09:04:38 +01:00
Daniel Agar
1425d87640
boards: px4_fmu-v5 sync all defconfigs
2020-11-19 11:21:47 -05:00
David Sidrane
b6f24eefb2
The PX4IO driver uses DMA but not NuttX's TXDMA
2020-11-19 09:39:08 -05:00
Daniel Agar
963d101375
boards: fmu-v5 debug and stackcheck increase interrupt stack
2020-11-15 17:00:11 -05:00
BazookaJoe1900
66edc822fe
boards: px4/fmu-v5 fix DMAmap documentation
...
- fixed notes and removed none used definitions
- set defconfig to define UART8_RXDMA and UART8_TXDMA though the DMA is not handled by nuttx, just to clarity
2020-11-12 11:26:45 -05:00
Daniel Agar
c60743b306
boards: NuttX increase file name max 32 -> 40
2020-11-08 12:51:59 -05:00
Daniel Agar
233949a377
NuttX upgrade to 10.0.0+ defconfig changes
2020-10-28 14:25:25 -04:00
David Sidrane
075690af9d
px4_fmu-v5: Updates for NuttX 9.1.0+ External schedule_note
2020-09-16 21:32:04 -04:00
David Sidrane
8e3ba3b0b3
px4_fmu-v5: Updates for NuttX 9.1.0+ External schedule_note
2020-09-16 21:32:04 -04:00
David Sidrane
d2e7542e39
px4_fmu-v5: Updates for NuttX 9.1.0+ External schedule_note
2020-09-16 21:32:04 -04:00
David Sidrane
dab2069f53
px4_fmu-v5: Updates for NuttX 9.1.0+ External schedule_note
2020-09-16 21:32:04 -04:00
David Sidrane
e3f5af4887
px4_fmu-v5: Updates for NuttX 9.1.0+ External schedule_note
2020-09-16 21:32:04 -04:00
David Sidrane
8a3f4f285a
px4_fmu-v5: Updates for NuttX 9.1.0+ External schedule_note
2020-09-16 21:32:04 -04:00
David Sidrane
f9adf861dc
spracing_h7extreme Updates for NuttX 9.1.0-
2020-09-16 21:32:04 -04:00
David Sidrane
b52e10720e
px4_fmu-v5 Updates for NuttX 9.1.0-
...
px4_fmu-v5: defconfig MMCSD enable multiblock
2020-09-16 21:32:04 -04:00
Daniel Agar
3fa9ff6d20
boards: px4_fmu-v5_debug increase LPWORK stack 1632 -> 1728 bytes
2020-09-06 18:36:30 -04:00
Daniel Agar
dd9676b73e
boards: px4/fmu-v5_debug increase interrupt stack 512 -> 768 bytes
2020-09-01 20:04:06 -04:00
Daniel Agar
2c3441aa90
boards: reduce CONFIG_NFILE_DESCRIPTORS 15 -> 12
...
- reduced now that calibration uses uORB::Subscription
- can likely be reduced further (perhaps < 8) with additional testing
2020-08-21 10:12:13 -04:00
David Sidrane
329ed6e273
px4_fmu-v5/v5x: Re-enable TXDMA
2020-08-11 12:27:28 -04:00
Daniel Agar
e3d31a881e
boards: NuttX disable posix message queues
2020-07-17 17:00:21 -04:00
Daniel Agar
b277840233
boards: create px4_fmu-v5_debug build with assertions enabled
2020-07-06 11:13:15 -04:00
Daniel Agar
5e7d2e830d
boards: delete old board.h boilerplate
2020-06-08 19:10:33 -04:00
Daniel Agar
28d2aca699
boards: include all procfs entries on boards that aren't flash constrained
2020-05-01 20:59:57 -04:00
Daniel Agar
8d0c92003a
boards: remove all CONFIG_NXFONTS_DISABLE*
2020-05-01 20:59:57 -04:00
Beat Küng
34c75f2d36
boards: temporarily disable UART TX DMA
...
work-around for https://github.com/PX4/Firmware/issues/14659 .
This can be reverted when fixed properly.
2020-04-27 08:47:46 -04:00
Daniel Agar
66eacd24bc
px4_fmu-v5_stackcheck: update stack sizes and add to Jenkins
...
- increase stack sizes to run cleanly under stackcheck
- this is likely overkill for most boards, but using stackcheck to set our minimum ensures we have a very safe margin on regular builds and it's something we can currently afford
- remove holybro_durandal-v1_stackcheck from test rack (there's only one unit)
2020-04-11 21:16:10 -04:00
Daniel Agar
a89bba470a
boards: STM32F76xxx/STM32F77xxx linker add ITCM RAM and .ramfuncs handling
...
- this doesn't currently change anything, but gets us ready to start
experimenting with using the small amount of instruction tightly memory
on STM32F7
- the .ramfuncs section works with NuttX CONFIG_ARCH_RAMFUNCS
2020-04-08 13:20:54 -04:00
Daniel Agar
40b1043e12
NuttX boards minor lpwork and init stack increases
2020-04-02 23:39:17 -04:00
Daniel Agar
15332a7e56
boards: reduce CONFIG_NFILE_DESCRIPTORS 20 -> 15
2020-04-01 16:17:14 -04:00
Daniel Agar
44bec269b0
boards: update all NuttX configs CONFIG_NSH_MAXARGUMENTS 12 -> 15
2020-03-25 17:59:22 -04:00
Daniel Agar
8738c26426
boards: enable NuttX SPI DMA buffers
...
- update to NuttX with stm32f4 and stm32f7 SPI DMA internal buffers
- remove explicit DMA buffer allocations from new IMU drivers
- restore original BOARD_DMA_ALLOC_POOL_SIZE
- decrease SPI DMA thresholds based on fmu-v2/v3/v4/v5 bench testing
2020-03-22 19:24:26 -04:00
Daniel Agar
b73ec18abb
boards: add px4_fmu-v4 and px4_fmu-v5 optimized (-O3) build variants
2020-03-22 17:50:17 -04:00
Daniel Agar
0ce9e113ff
boards: stm32f4/f7 enable SPI_DMATHRESHOLD=32
2020-03-11 22:08:37 -04:00
Beat Küng
179c89b6bd
board configs: extend board_dma_map.h with a table
2020-03-11 22:08:37 -04:00
Daniel Agar
6ed4b6978e
px4_fmu-v5: add board_dma_map.h and enable SPI1 DMA
2020-03-11 22:08:37 -04:00
Daniel Agar
46a09b711f
boards: increase STDIO buffer size where we can afford it
2020-03-11 17:19:44 -04:00
Daniel Agar
505afc6063
boards: increase LPWORKSTACKSIZE 1536 -> 1600
2020-03-10 12:53:01 -04:00
Beat Küng
d74d094940
nuttx configs: disable nuttx timers which are used for PWM output
...
These are not required, and to be consistent we enforce disabling them now.
2020-02-13 03:49:16 -08:00