* Add new INS driver sbgECom
Implement sbgECom messages handling to provide IMU sensors, GNSS and EKF data to the autopilot
Be able to parametrize the serial port, baudrate and the communicating mode
Clone sbgECom library only if sbgecom support is enabled and apply a patch
Be able to send SBG Systems INS settings in several ways when starting sbgecom driver
* Fix sensor airspeed simulator units
* Fix HIGHRES_IMU pressure unit
* Allow HIGHRES_IMU to support 4 IMUs
* sbgECom: Add documentation
* Use submodule instead of fetching sbgECom using CMake
* Remove patch strategy
* Fix dates
* Remove patch file
* Update SBG dev type ID
Co-authored-by: Jacob Dahl <37091262+dakejahl@users.noreply.github.com>
---------
Co-authored-by: Samuel Toledano <samuel.toledano@sbg-systems.com>
Co-authored-by: Jacob Dahl <37091262+dakejahl@users.noreply.github.com>
* Create a dummy BAHRS driver
* Resolve compilation
* Switch back to cpp, fix compilation
* Create module.yaml
* Implement required module APIs and open serial port
* Revise info and error messages
* Poll serial port
* Push received bytes into the ring buffer
* Process data buffer (1)
* Process data buffer (2)
* Process data buffer (3)
* Process data buffer (4)
* Process data buffer (5)
* Process data buffer (6)
* Implement and use initialize() and deinitialize() methods
* Implement print_usage() and print_status()
* Collect all config constants in a class
* Put info about next found message into a class
* Print CRC failure count
* Remove unneeded print
* Add comments
* Disable EKF2, advertise vehicle attitude
* Decode and publish BAHRS signals (1)
* Run the driver as an additional source of sensor signals
* Add tiny noise to baro-inertial pressure signal
* Fix the sensor ID
* Add copyrights
* Fix formatting
* Remove redundant newline character
* Fix long parameter name
* Fix findings (1)
* Fix finding (2)
* Fix formatting
* Fix the timeout value
* Remove aliases
* Fix copyright
* Fix indent
* Comply with naming convention
* Rework comparison to false
* Reduce nesting (1)
* Reduce nesting (2)
* Reduce nesting (3)
* Fix BAHRS sensor ID
* fix max-hagl restriction to position/altitude control
* max hagl vel restriction in ManAcc position mode
* use interpolate func, change naming
* simplyfied vertical vel limitation
* move velocity-constraint adjustment to StickAccelXY
When the yaw estimate is converging, the controller makes the drone yaw
in order to follow the current setpoint. This is unintuitive for the
pilot and it is preferable if the drone continues to fly towards the
same physical direction.
- vectornav library (libvnc) fixed for NuttX
- open serial port O_NONBLOCK (like __APPLE__)
- set serial port baud rate with cfsetspeed (like __APPLE__)
- vectornav backend thread increase stack and run at higher priority (SCHED_FIFO)
Valentin Bugrov