2.6 KiB
CUAV P8 Telemetry Radio
CUAV P8 Radio is a long range (>60km) and high data rate (375 Kbps) remote data transmission module for drones that works plug-and-play with PX4.
It supports multiple modes such as point-to-point, point-to-multipoint, and relay communication.
주요 특징
- Long range: >60km (depending on the antenna and environment, up to 100 km).
- Supports point-to-point, point-to-multipoint, and repeater modes.
- Up to 2W power (fixed frequency 2W; frequency hopping 1W)
- Up to 345 Kbps transfer rate.
- Supports 12v~60V operating voltage.
- Unit can operate either as ground station modem or aircraft modem.
- Independent power supply for more stable operation
- USB Type-C port, integrated USB to UART converter
구매처
PX4 설정
The CUAV P8 Radio comes pre-configured (baud rate 57600, broadcast mode) for use with PX4.
It should require no additional setup if connected to TELEM1 OR TELEM2.
On some flight controllers, or if used with a different serial port, you may need to configure the port for MAVLink communication.
:::tip P8 Configuration provides full information about radio configuration, if required. :::
핀배열
Data Port
| 핀 | C-RTK GPS 6P | 핀 | Pixhawk standard pins |
|---|---|---|---|
| 1 | 5V+(NC) | 1 | VCC |
| 2 | RX | 2 | TX |
| 3 | TX | 3 | RX |
| 4 | RTS | 4 | RTS |
| 5 | CTS | 5 | CTS |
| 6 | GND | 6 | GND |
배선
Connect the CUAV P8 Radio to the TELEM1/TELEM2 interface of the flight controller and use a battery or BEC to power the module.
The required cables are included in the package.
:::tip CUAV P8 Radio does not support power supply from the flight controller, it needs to be connected to a 12~60v battery or BEC. :::
More information
CUAV P8 Radio (Official Guide)