mirror of
https://gitee.com/mirrors_PX4/PX4-Autopilot.git
synced 2026-04-14 10:07:39 +08:00
27 lines
1.2 KiB
Markdown
27 lines
1.2 KiB
Markdown
# DroneCAN ESCs
|
|
|
|
PX4 supports DroneCAN compliant ESCs.
|
|
For more information, see the following articles for specific hardware/firmware:
|
|
|
|
- [PX4 Sapog ESC Firmware](sapog.md)
|
|
- [Holybro Kotleta 20](holybro_kotleta.md)
|
|
- [Zubax Telega](zubax_telega.md)
|
|
- [Vertiq](../peripherals/vertiq.md) (larger modules)
|
|
- [VESC Project](../peripherals/vesc.md)
|
|
- [RaccoonLab Cyphal and DroneCAN PWM nodes](raccoonlab_nodes.md)
|
|
|
|
## 하드웨어 설정
|
|
|
|
General DroneCAN hardware configuration is covered in [DroneCAN > Hardware Setup](../dronecan/index.md#hardware-setup).
|
|
|
|
DroneCAN ESCs should be on their own dedicated CAN interface(s) because ESC messages can saturate the bus and starve other nodes of bandwidth.
|
|
|
|
## PX4 설정
|
|
|
|
DroneCAN peripherals are configured by following the procedure outlined in [DroneCAN](../dronecan/index.md).
|
|
|
|
In addition to the general setup, such as setting `UAVCAN_ENABLE` to `3`:
|
|
|
|
- Select the specific CAN interface(s) used for ESC data output using the [UAVCAN_ESC_IFACE](../advanced_config/parameter_reference.md#UAVCAN_ESC_IFACE) parameter (all that all interfaces are selected by default).
|
|
- Configure the [motor order and servo outputs](../config/actuators.md).
|