Show correct battery voltage for v2 boards

src/modules/sensors/sensor_params.c

@@ -68,7 +68,7 @@ PARAM_DEFINE_FLOAT(SENS_ACC_XSCALE, 1.0f);
 PARAM_DEFINE_FLOAT(SENS_ACC_YSCALE, 1.0f);
 PARAM_DEFINE_FLOAT(SENS_ACC_ZSCALE, 1.0f);
 
-PARAM_DEFINE_FLOAT(SENS_DPRES_OFF, 1667);
+PARAM_DEFINE_FLOAT(SENS_DPRES_OFF, 0);
 
 PARAM_DEFINE_FLOAT(RC1_MIN, 1000.0f);
 PARAM_DEFINE_FLOAT(RC1_TRIM, 1500.0f);
@@ -157,8 +157,12 @@ PARAM_DEFINE_FLOAT(RC14_DZ, 0.0f);
 PARAM_DEFINE_INT32(RC_TYPE, 1); /** 1 = FUTABA, 2 = Spektrum, 3 = Graupner HoTT, 4 = Turnigy 9x */
 PARAM_DEFINE_INT32(RC_RL1_DSM_VCC, 0); /* Relay 1 controls DSM VCC */
 
+#ifdef CONFIG_ARCH_BOARD_PX4FMU_V2
+PARAM_DEFINE_FLOAT(BAT_V_SCALING, 0.0082f);
+#else
 /* default is conversion factor for the PX4IO / PX4IOAR board, the factor for PX4FMU standalone is different */
 PARAM_DEFINE_FLOAT(BAT_V_SCALING, (3.3f * 52.0f / 5.0f / 4095.0f));
+#endif
 
 PARAM_DEFINE_INT32(RC_MAP_ROLL, 1);
 PARAM_DEFINE_INT32(RC_MAP_PITCH, 2);

src/modules/sensors/sensors.cpp

@@ -92,8 +92,35 @@
 #define BARO_HEALTH_COUNTER_LIMIT_OK 5
 #define ADC_HEALTH_COUNTER_LIMIT_OK  5
 
-#define ADC_BATTERY_VOLTAGE_CHANNEL	10
-#define ADC_AIRSPEED_VOLTAGE_CHANNEL	11
+/**
+ * Analog layout:
+ * FMU:
+ * IN2 - battery voltage
+ * IN3 - battery current
+ * IN4 - 5V sense
+ * IN10 - spare (we could actually trim these from the set)
+ * IN11 - spare (we could actually trim these from the set)
+ * IN12 - spare (we could actually trim these from the set)
+ * IN13 - aux1
+ * IN14 - aux2
+ * IN15 - pressure sensor
+ * 
+ * IO:
+ * IN4 - servo supply rail
+ * IN5 - analog RSSI
+ */
+
+#ifdef CONFIG_ARCH_BOARD_PX4FMU_V1
+  #define ADC_BATTERY_VOLTAGE_CHANNEL	10
+  #define ADC_AIRSPEED_VOLTAGE_CHANNEL	11
+#endif
+
+#ifdef CONFIG_ARCH_BOARD_PX4FMU_V2
+  #define ADC_BATTERY_VOLTAGE_CHANNEL	2
+  #define ADC_BATTERY_CURRENT_CHANNEL	3
+  #define ADC_5V_RAIL_SENSE		4
+  #define ADC_AIRSPEED_VOLTAGE_CHANNEL	15
+#endif
 
 #define BAT_VOL_INITIAL 0.f
 #define BAT_VOL_LOWPASS_1 0.99f