Files
PX4-Autopilot/boards/px4/fmu-v2/multicopter.cmake
T
Daniel Agarandbresch f9794e99f8 move hover_thrust_estimator to new module (mc_hover_thrust_estimator)
* MC_HTE: unitialize with hover_thrust parameter
* MC_HTE: constrain hover thrust setter between 0.1 and 0.9
* MC_HTE: integrate with land detector and velocity controller
* MCHoverThrustEstimator: Always publish an estimate even when not fusing measurements. This is required as the land detector and the position controller need to receive a hover thrust value.

* MC_HTE: use altitude agl threshold to start the estimator
local_position.z is relative to the origin of the EKF while dist_bottom
is above ground

Co-authored-by: bresch <brescianimathieu@gmail.com>
2020-03-11 21:20:54 -04:00

86 lines
1.2 KiB
CMake

px4_add_board(
PLATFORM nuttx
VENDOR px4
MODEL fmu-v2
LABEL multicopter
TOOLCHAIN arm-none-eabi
ARCHITECTURE cortex-m4
ROMFSROOT px4fmu_common
IO px4_io-v2_default
#UAVCAN_INTERFACES 2
CONSTRAINED_FLASH
SERIAL_PORTS
GPS1:/dev/ttyS3
TEL1:/dev/ttyS1
TEL2:/dev/ttyS2
TEL4:/dev/ttyS6
DRIVERS
adc
barometer/ms5611
#batt_smbus
camera_capture
camera_trigger
distance_sensor # all available distance sensor drivers
gps
imu/l3gd20
imu/lsm303d
imu/mpu6000
#imu/mpu9250
irlock
lights/rgbled
magnetometer/hmc5883
#optical_flow/px4flow
px4fmu
px4io
tone_alarm
MODULES
#attitude_estimator_q
battery_status
camera_feedback
commander
dataman
ekf2
#events
land_detector
landing_target_estimator
load_mon
#local_position_estimator
logger
mavlink
mc_att_control
mc_hover_thrust_estimator
mc_pos_control
mc_rate_control
navigator
rc_update
sensors
sih
#temperature_compensation
vmount
SYSTEMCMDS
#bl_update
#config
#dumpfile
#esc_calib
hardfault_log
#i2cdetect
#led_control
mixer
#motor_ramp
#motor_test
mtd
#nshterm
param
perf
pwm
reboot
#sd_bench
top
#topic_listener
tune_control
#usb_connected
ver
#work_queue
)