Update SDP3x Airspeed Correction (#8242)

Update the model for the standard configuration based on the model from Sensirion and add also an option to do the tube pressure loss correction from Sensirion for other configurations.

src/modules/sensors/sensor_params.c

@@ -39,24 +39,49 @@
 PARAM_DEFINE_INT32(CAL_BARO_PRIME, 0);
 
 /**
- * Airspeed sensor pitot model
+ * Airspeed sensor compensation model for the SDP3x
  *
- * @value 0 HB Pitot
+ * Model with Pitot
+ * 		CAL_AIR_TUBED_MM: Not used, 1.5 mm tubes assumed.
+ * 		CAL_AIR_TUBELEN: Length of the tubes connecting the pitot to the sensor.
+ * Model without Pitot (1.5 mm tubes)
+ * 		CAL_AIR_TUBED_MM: Not used, 1.5 mm tubes assumed.
+ * 		CAL_AIR_TUBELEN: Length of the tubes connecting the pitot to the sensor.
+ * Tube Pressure Drop
+ * 		CAL_AIR_TUBED_MM: Diameter in mm of the pitot and tubes, must have the same diameter.
+ * 		CAL_AIR_TUBELEN: Length of the tubes connecting the pitot to the sensor and the static + dynamic port length of the pitot.
  *
+ * @value 0 Model with Pitot
+ * @value 1 Model without Pitot (1.5 mm tubes)
+ * @value 2 Tube Pressure Drop
  * @group Sensor Calibration
  */
-PARAM_DEFINE_INT32(CAL_AIR_PMODEL, 0);
+PARAM_DEFINE_INT32(CAL_AIR_CMODEL, 0);
 
 /**
- * Airspeed sensor tube length
+ * Airspeed sensor tube length.
+ *
+ * See the CAL_AIR_CMODEL explanation on how this parameter should be set.
+ *
  * @min 0.01
- * @max 0.5
+ * @max 2.00
  * @unit meter
  *
  * @group Sensor Calibration
  */
 PARAM_DEFINE_FLOAT(CAL_AIR_TUBELEN, 0.2f);
 
+/**
+ * Airspeed sensor tube diameter. Only used for the Tube Pressure Drop Compensation.
+ *
+ * @min 0.1
+ * @max 100
+ * @unit millimeter
+ *
+ * @group Sensor Calibration
+ */
+PARAM_DEFINE_FLOAT(CAL_AIR_TUBED_MM, 1.5f);
+
 /**
  * Differential pressure sensor offset
  *