New Crowdin translations - ko (#25200)

Co-authored-by: Crowdin Bot <support+bot@crowdin.com>

docs/ko/config/actuators.md

@@ -379,7 +379,7 @@ The following functions can only be applied to FMU outputs:
   Enabled when [`PPS_CAP_ENABLE==0`](../advanced_config/parameter_reference.md#PPS_CAP_ENABLE)
 
 :::info
-The functions are defined in source at [/src/lib/mixer_module/output_functions.yaml](https://github.com/PX4/PX4-Autopilot/blob/main/src/lib/mixer_module/output_functions.yaml).
+The functions are defined in source at [/src/lib/mixer_module/output_functions.yaml](https://github.com/PX4/PX4-Autopilot/tree/main/src/lib/mixer_module/output_functions.yaml).
 This list is correct at PX4 v1.15.
 :::
 
@@ -507,7 +507,6 @@ For each motor:
 
 2. Slowly move the slider up until it snaps to the _minimum_ position.
   In this position the motor is set to the outputs `minimum` value.
-
   - 이 위치에서 모터가 매우 느리게 회전하는 지 확인합니다.
   - If the motor is not spinning, or spinning too fast you will need to adjust the corresponding PWM `minimum` value in the [Actuator Outputs](#actuator-outputs) such that the motors barely spin.
 
@@ -518,7 +517,6 @@ For each motor:
 :::
 
 3. Increase the slider value to a level where you can verify that the motor is spinning in the correct direction and that it would give a positive thrust in the expected direction.
-
   - The expected thrust direction can vary by vehicle type.
     For example in multicopters the thrust should always point upwards, while in a fixed-wing vehicle the thrust will push the vehicle forwards.
   - For VTOL, thrust should point upwards when the Tilt Servo is at 0 degrees as defined the [Tilt Servo Convention](#tilt-servo-coordinate-system).
@@ -568,7 +566,6 @@ To set these up:
   If the control surface moves in the opposite direction, click on the `Rev Range` checkbox to reverse the range.
 
 3. Move the slider again to the middle and check if the Control Surfaces are aligned in the neutral position of the wing.
-
   - If it is not aligned, you can set the **Trim** value for the control surface.
 
     ::: info

docs/ko/config/index.md

@@ -7,7 +7,7 @@ Most other steps can be done out of order, except for [tuning](#tuning), which m
 
 ## 전제 조건
 
-Before starting you should [Download QGroundControl](https://qgroundcontrol.com/downloads/) and install it on your **desktop** computer.
+Before starting you should [Download QGroundControl](https://docs.qgroundcontrol.com/master/en/qgc-user-guide/getting_started/download_and_install.html) and install it on your **desktop** computer.
 Then open the QGC application menu ("Q" icon in the top-left corner) and choose **Vehicle Setup** in the _Select Tool_ popup:
 
 ![QGC Main Menu Popup: highlighting Vehicle Setup](../../assets/qgc/setup/menu_setup.png)

docs/ko/config/joystick.md

@@ -2,7 +2,7 @@
 
 A [computer joystick](https://en.wikipedia.org/wiki/Joystick) or gamepad connected through _QGroundControl_ can be used to manually control the vehicle (_instead_ of using an [RC Transmitter](../config/radio.md)).
 
-This approach may be used by manual control units that have an integrated ground control station (like the _UAVComponents_ [MicroNav](https://uxvtechnologies.com/ground-control-stations/micronav/) shown below).
+This approach may be used by manual control units that have an integrated ground control station (like the _UAVComponents_ [MicroNav](https://www.uxvtechnologies.com/ground-control-stations/micronav) shown below).
 조이스틱은 일반적으로 비행 시뮬레이션용으로 많이 사용합니다.
 
 ![Joystick MicroNav](../../assets/peripherals/joystick/micronav.jpg)

docs/ko/config/safety.md

@@ -319,8 +319,8 @@ The [failure detector](#failure-detector), if [enabled](#CBRK_FLIGHTTERM), can a
 외부 작동 시스템은 비행 컨트롤러 포트 AUX5 (또는 AUX 포트가없는 보드의 MAIN5)에 연결되어야 하며 아래의 매개 변수들을 사용하여 설정합니다.
 
 :::info
-External ATS is required by [ASTM F3322-18](https://webstore.ansi.org/Standards/ASTM/ASTMF332218).
-One example of an ATS device is the [FruityChutes Sentinel Automatic Trigger System](https://fruitychutes.com/uav_rpv_drone_recovery_parachutes/sentinel-automatic-trigger-system.htm).
+External ATS is required by [ASTM F3322-18](https://webstore.ansi.org/standards/astm/ASTMF332218).
+One example of an ATS device is the [FruityChutes Sentinel Automatic Trigger System (SATS-MINI)](https://fruitychutes.com/uav_rpv_drone_recovery_parachutes/sentinel-automatic-trigger-system).
 :::
 
 | 매개변수                                                                                                                                                                    | 설명                                                                                                                                                                               |